Enquiry Form

  • Registration
  • Specification
  • Performance
  • Hardware
  • Timing and Quantity
  • Quality

Registration

Fields marked by * are mandatory

Specification

Fields marked by * are mandatory

Measurement Units*

System Requirement*

Application Sector*

Torque and Speed Location*

Approximate Duty

Short Description of Intended Application*

Performance

Fields marked by * are mandatory

Power

Maximum Speed*

Please specify the maximum Motor Shaft speed.

rev/min

rev/min

Target Peak Torque: Intermittent*

Please specify the maximum intermittent torque required at the Motor Shaft and the expected duration.

Nm

ft-lb

Target Peak Power: Intermittent*

Please specify the maximum intermittent power required.

kW

W

Target Torque: Continuous duty*

Please specify the maximum continuous duty torque required at the Motor Shaft.

Nm

ft-lb

Target Power: Continuous duty*

Please specify the maximum continuous duty power required.

kW

W

Transmission

Transmission Reduction Ratio

nMotor/nOutput (RPM/RPM) Shaft.

-

Maximum Road Wheel Speed

If applicable, e.g. for wheeled vehicles.

rev/min

rev/min

Road Wheel Rolling Radius

If applicable, e.g. for wheeled vehicles.

mm

inches

Electrics

Minimum Supply Voltage*

Please specify the minimum supply voltage to the system at which full performance is required.

VDC

VDC

Maximum Supply Voltage*

Please specify the maximum supply voltage to the system.

VDC

VDC

Nominal Cooling Inlet Temperature

Please advise maximum coolant temperature at which full performance is required.

°C

°F

Maximum Phase Current

If not using an Helix inverter, please specify the maximum allowable phase current.

Arms

Arms

Inverter: Switching frequency

If not using an Helix inverter, please specify the maximum allowable PWM switching frequency.

kHz

kHz

Installation

Fields marked by * are mandatory

Mass: Target

If there is a motor or EDU mass target, please specify.

kg

lb

Package: Maximum Height

If there is a package height limit please specify.

mm

inches

Package: Maximum Diameter*

If there is a package width limit please specify. ‘Width’ is assumed to be perpendicular to motor shaft axis.

mm

inches

Package: Maximum Length

If there is a package length limit please specify. ‘Length’ is assumed to be parallel to motor shaft axis.

mm

inches

System structure: Loading

Will the system be expected to carry any external loads, such as forming a part of the vehicle structure? If so, please add any basic notes in the description to help us understand these.

System orientation: Motor Axis

Please specify the nominal orientation (e.g. shaft horizontal or vertical).

Timing & Quantity

Fields marked by * are mandatory

Quantity: Development Units

Please specify the estimated number of customer development units required. If there are to be multiple phases, then feel free to add breakdown details below.

n

Quantity: Production Units

If applicable, for the production programme, specify the number of units per year and the expected production duration.

n,years

Date: 1st Development Unit

Please specify the required date for the first development unit.

mm/yy

Date: 1st Production Unit

If applicable, please specify the expected start of production date.

mm/yy

Quality

Fields marked by * are mandatory

Quality Compliance

Please specify any quality requirements specific to this application.

Regulatory Compliance

Please indicate whether there are any specific industry Technical Standards or Regulations applicable for this application.

IMDS Compliance

Please indicate if there are specific IMDS and/or Reach/RoHS compliance requirements for this application.

Nominal Product Life

Please specify any vehicle level life target (hours or Km).

Warranty

If determined, please specify warranty requirements or expectations.

Finished

This site is protected by hCaptcha and its Privacy Policy and Terms of Service apply.

Copyright © 2022 Integral Powertrain Limited, Merlewood Drive, Shenley Wood, Milton Keynes, MK5 6GR

Site designed by Design Inc